It is not necessary to use the box tamper if another module sharing the same box is equipped with one.Ģ. TAMP and the COM terminals (normally closed).ġ. Used for connection of the box’s tamper switch between the Ensure that the incoming AUX (usually red) wire from the ProSYS Bus is disconnected! Maximum permitted wire run for Bus wiring from the SMPS to the ProSYS is 300m (1000 ft)!ĭO NOT connect the AUX (RED) terminal to the ProSYS BUS. The wires respectively, point to point, according to the indicated
Output module to the ProSYS communication Bus. Perform a diagnostic test of the SMPS output and battery, using the ProSYS software as described in the User Programming Menu section on page 13.īUS terminals: used to connect the SMPS and its Utility Ê Supports 1.7 Amp Siren, with remote reading of siren currentġ1. Ê Automatic battery protection and remote voltage reading Ê Advanced remote diagnostics – includes remote Upload/download or keypad reading of voltage output and current under load Ê 3A switching mode power supply with self supervision
The SMPS includes two Utility Outputs, which may be separately programmed by the ProSYS as regular utility outputs. Up to 8 modules can be added to the system to ensure reliable operation of the system with its multiple devices and accessories. It supports a standby battery and is supervised for loss of Mains, Battery, failure of its auxiliary output power and loss of its sounder device. It provides a total current capacity of up to 3A with extensive remote diagnostics features that comply with EN50131requirements. The Switching Mode Power Supply (SMPS) is a reliable, supervised power supply expansion module, for use with RISCO’s ProSYS security systems.
0 kommentar(er)
